Buffalo GEN10K Manual de instrucciones descargar pdf (Pagina 11)

GEN10K 10,000 Surge Watts/7,000 Running Watts Portable Generator 11

PREPARING THE GENERATOR FOR USE

Using this Generator for the First-Time

STOP!

The following section describes the required steps for preparing this generator for the first use. Failure to correctly perform these steps

can damage this generator and/or shorten its life. If still unsure about how to perform any of these steps after reading this section, call

1-866-460-9436 Monday - Friday, 8 AM - 4 PM Central Time for customer service.

If this generator is being used for the first time, the following few steps are required to prepare it for operation:

Step 1 - Add Oil

This generator requires engine oil to function. Engine oil is a major factor affecting engine performance and service life. When new from

the package, this generator contains no oil in the engine crankcase. The correct quantity of oil is equal to the oil capacity of the engine crankcase

and is 37.12 fluid oz (1.1 L) for this Model GEN10K 10,000 Surge Watts / 7,000 Running Watts Portable Generator. Add the correct quantity of oil

before operating this generator for the first time. When replenishing oil for subsequent use of this generator, always determine that this generator

has the correct quantity of oil.

Model GEN10K Oil Capacity (fluid oz./L)

37.12 ounces (1.1 Liter)

Model GEN10K Oil Type Recommended

SAE10W-30

To add oil:

1. Confirm that this generator is on a level surface.

2. Locate the Oil Access (Figure 1)

3. Using a funnel, add high detergent motor oil to fill the engine crankcase to the correct quantity as stated above. SAE10W-30 oil is recommended.

When the engine crankcase is full, the oil level should reach the lower lip of the oil filling opening as illustrated in Figure 2.

4. Replace the oil filler/dipstick cap.

Figure 1 –Oil Access

Figure 2 - Adding Oil

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sin comentarios

Buffalo GEN10K Manual de instrucciones Pagina 11