Buffalo WZR-1166DHP Manual de usuario descargar pdf (Pagina 10)

IP address error.

9 blinks (Red)**:

System error.

Continuously blinking*:

Updating firmware, saving settings, or initializing settings.

* Never unplug the AC adapter while the Buffalo LED is blinking continuously.

** Turn off AirStation, wait for a few seconds, then turn it back on.

*** Because the network addresses of both the Internet port (WAN port) and the LAN port are the same, it is not possible

to establish communication. Change the LAN-side IP address of the AirStation.

Back Panel

1 Access Point/Wireless Bridge Control Switch

This switch changes between access point mode and wireless bridge mode.

AP - access point (or router)

WB - wireless bridge

2 Mode button

If the switch above is in the “AP” position, this button switches the AirStation between router and access point

functionality. If the switch is in the “WB” position, the button has no effect.

3 USB Eject button

To dismount a USB hard drive, hold down this button until the USB LED flashes (about 3 seconds). The USB drive

can then be unplugged safely.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 113 114

Sin comentarios

Buffalo WZR-1166DHP Manual de usuario Pagina 10